Y-10 Original GRP Stain Remover Gel

PLEASE NOTE: FOR SALE TO PROFESSIONAL USERS ONLY

Still the original and best GRP hull stain remover! 

Y-10 is a stain absorbent gel, which is easy to apply, requires no rubbing and is non-abrasive so it won't damage the hull. It rapidly removes yellow/brown waterline and transom stains on white or light coloured fibreglass sailboats and powerboats. 

To use brush a thin coating of Y-10 over the stain wait 10 minutes while a mild chemical reaction causes the stains to vanish, then wash it off. The gel spreads easily and adheres to vertical and overhead surfaces. Y-10 is also effective at removing rust stains around engine exhaust ports and other fittings.

Care instructions

• Use of gloves essential and nose mask advised
• Do not use Y-10 on painted surfaces
• Contains Oxalic acid (less than 10%)

Product safety

Please note the following hazard warnings:

Hazard pictogram(s):
Signal word:	Danger
Hazard statement(s):	H317: May cause an allergic skin reaction. H350: May cause cancer H360FD: May damage fertility. May damage the unborn child.
Precautionary statement(s):	P201: Obtain special instructions before use. P202: Do not handle until all safety precautions have been read and understood. P261: Avoid breathing dust/fume/gas/mist/vapours/spray. P272: Contaminated work clothing should not be allowed out of the workplace. P280: Wear protective gloves/protective clothing/eye protection/face protection. P302 + P352: IF ON SKIN: Wash with plenty of water. P308 + P313: IF exposed or concerned: Get medical advice/attention. P333 + P313: If skin irritation or rash occurs: Get medical advice/attention. P362 + P364: Take off contaminated clothing and wash it before reuse. P405: Store locked up. P501: Dispose of contents/container in accordance with local/regional/national/international regulations.
Supplemental Hazard information (EU)	Not applicable.

  Safety Data Sheet pdf