Description
Torqeedo Solar charge controller specially adapted to the Power 48-5000 battery
Key Features
- Makes it possible to charge the Power 48-5000 with solar energy (solar panels not included)
- Switches the system on by itself when there is enough sunlight
- The integrated MPPT maximizes the energy output of the solar modules during charging with very high efficiency
- Up to 6 solar charge controllers can be connected in parallel
- Also charges the batteries while driving
- Only compatible with TorqLink motors
- Solar charging for systems with non-TorqLink motors is only possible with Power 24-3500 as a drive battery and solar charge controller (2207-00) or solar quick charge controller (2211-00)
- Compatible with the Power 48-5000 quick charger (2212-00)
- Not compatible with the Power 48-5000 charger (2213-00)
In the Box
- Charge controller incl. battery cable with fuse
- Spare fuse
- Crimp connector (2 pieces)
- Heat-shrink tubing (with adhesive, 2 pieces, each approx. 6 cm)
- TorqLink T cable
Specifications
- Maximum module rated current (Imp) 8 A
- Maximum module short-circuit current (Isc) 9 A
- Minimum module voltage 12 V
- Maximum module nominal voltage @ STC (Vmp) 40.8 V
- Maximum module open-circuit voltage (Voc) 48 V
- Maximum module power 325 Wp
- Parallel connection up to 6 charge controllers in parallel
- Charge cut-off voltage 49.5 V
- Maximum efficiency 99%
- Operating point efficiency 96 to 99%
- Standby consumption < 1 mA
- IP code Charge controller (without fuse holder): Protected from immersion IP67
- Fuse holder: Protected from water spray IP64
- Solar module connection - Cable not preassembled
– Colour coding: Yellow = plus, black = minus
– Cable length approx. 0.15 m - Battery connection – Ring cable lug M8/red for positive pole, M10/black for negative pole
– Cable length approx. 1.5 m - Data connection – TorqLink socket on the unit
– TorqLink T-cable included in scope of supply
– Cable length approx. 0.9 m - Dimensions 180 mm × 82 mm × 56 mm
- Weight 720 g