Seastar Teleflex Rack Steering Cable SSC134

This SeaStar Rack & Pinnion, Mechanical Steering is the best choice for stern drives outboard, inboards and other power assisted steering applications.

The new rack system features precision control and the comfort of a four turn helm . The cable, helm and bezel kit are easy to install with low on-going maintenance.

Features

• Requires Steering Helm SH5210P & Bezel Kit  SB39526P for full install 
• Precise, easy 4 turns lock-to- lock
• Rack & Pinnion System
• Standard 3/4” round tapered steering shaft
• Stainless steel cable output ends •
• Meets A.B.Y.C. standards
• Meets N.M.M.A. certification requirements

Complete system requires these components

• 1 x TXSSC134-Length Cable
• 1 x TXSH5210P Helm
• 1 x TXSB39526P Bezel Kit
• 1 x Steering Wheel of Choice
• 1 x Cable End to Rudder Fitting Kit  -Select from range

How to measure a replacement cable installation

Measure Existing Cable as follows: Measure plastic cable jacket ("Y" dimension shown in above drawing) in inches, add 30", and round up to next foot. Order that length cable.

How to measure first-time steering cable installation

Measure cable routing path in boat as follows:

A = Center line of the wheel to gunwale (inches)
B = Dash to transom (inches)
C = Gunwale to cable connection at centered tiller (inches)

For tilt tube mounting, add A + B + C + 6", and round up to the next foot. Order that length of cable. For transom/splashwell/stringer support mounting, add A + B + C, then subtract 6" and round up to the next foot. Order that length of cable.