Rule-A-Matic Float Switch - 35A

Year after year, the Rule-A-Matic 35A has been the switch of choice for boaters the world over. Rule's latest design now includes a removable base for easy cleaning and servicing, a mercury free snap switch tested to over one million cycles and marine grade "blocked" wire. Designed for pumps drawing up to 14 Amps

Features

• For automatic on/off bilge pump control
• Marine quality corrosion free wiring .
• Switch design prevents rapid on/off cycling.
• Environmetally friendly - New Mercury free model
• Removeable base for cleaning

Specification

• Voltage:For 12 -24v DC
• Max.Amps: Suitable for pumps drawing up to 14 Amps
• Dimensions: 127mm long, 40mm wide, 110mm high (at max. lift)

Mounting Position and Installation

The Rule Float Switch should be mounted at the lowest point in the bilges or at the height required to control the water level. Ensure the switch is upright and that there is sufficient clearance for the float when in the fully up position.

It should be mounted fore and aft with the hinged end pointing towards the bow. This helps prevent rapid on/off cycling if the boat rolls sideways

The switched should be installed on the positive lead. Use tinned wire and add a Panel switch, such as the Rule No 45 to complete the install - See related products.