Owatrol Polytrol Colour Restorer 1L

Owatrol Polytrol is a deep penetrating oil which restores the original colour and appearance of dull or tarnished plastics, gelcoats, metals, and other surfaces.

It penetrates the surface, re-wetting the pigments to restore their lustre and colour which has been lost through exposure to sunlight, rain, and pollution and it also gives corrosion protection.  When used on tarnished metals, it brings back the shine and gives long-term protection against corrosion.

Features and uses

• Revives the colour and appearance of tarnished and dulled plastics and fibreglass (GRP) (car bumpers, boat hulls, garden furniture, shutters).
• Restores marble, tiles, tombstones, slate, terracotta tiles where the colour and look has faded.
• Rejuvinates and restores flat and chalky paint and varnishes dulled by weathering.
• Restore the shine and protects chrome or polished metals: aluminum, chrome, brass, bronze.

Preparation

Before implementing POLYTROL, always make sure the surfaces are clean and free of grease, silicone, and always dry. 
If cleaning is necessary, use a solvent on metal or a mixture of water and detergent, preferably on plastic NET-TROL.
Rinse well and allow to dry at least 12 hours.
Hide areas that are not treated.

Application

Before implementing POLYTROL, always make sure the surfaces are clean and free of grease, silicone, and always dry. If cleaning is necessary, use a solvent on metal or a mixture of water and detergent, preferably on plastic NET-TROL. Rinse well and allow to dry at least 12 hours. Hide areas that are not treated.
Carefully apply a layer of saturated POLYTROL. Beware of runs (for sanding metal surfaces thoroughly with steel wool very fine, well soaked POLYTROL).
Leave on for 10-20 minutes then remove the excess product by wiping with a clean lint or paper towel.
Allow at least 24 hours before use.

Notes

• Treat small areas in stages to avoid an uncontrolled drying POLYTROL.
• Avoid using the POLYTROL^® on hot surfaces or direct sunlight.
• Although POLYTROL is not highly flammable soaked rags should not be discarded as such directly to the trash (risk of self ignition) to dry, first, flat and open.

Coverage

• Coverage: 18 m²/l
• Application temperature : +5°C to +35°C
• Working time before wipe off : 10 to 20mn.