International Cruiser 250 Antifoul - 3L

International Cruiser 250 is a polishing antifouling, resulting in consistent antifouling performance while the boat is motion. Offers year-round protection, in all but the worst fouling areas. Use antifouling paints safely. Always read the label and product information before use.

Features

• Offers a full year's protection
• Protects against all kinds of fouling
• Suitable for both powerboats and sailboats

Specification

• Brand: International
• Capacity: 3L
• Area: Below the Waterline
• Suitable for: Hull
• Finish/Sheen: Matt
• Type of Antifouling: Ablative
• Suitable Water Types: Sea Water, Fresh Water, Brackish Water
• Substrates: Epoxy Composite / Carbon Fibre, Cast Iron, GRP/FRP, Lead, Steel, Wood
• Application Method: Brush, Roller
• Recommended Number of Coats: 2 - 3
• Practical Coverage: 9 m²/L
• Typical Shelf Life: 2 Years

Colours Avaliablity

• Dover White
• Red
• Blue
• Navy
• Black

Preparation 

PREVIOUSLY PAINTED SURFACE

• In Good Condition: All fouling and contamination must be thoroughly removed including the leached layer. Use high pressure fresh water wash (3000 psi/207 bar) and/or scraping and wet sanding with typically 80­120 grade paper. Do not dry sand. If old antifouling is incompatible or unknown, seal with suitable International Paint barrier/sealer coat.
• In Poor Condition: Use Interstrip to remove all traces of antifouling.

PRIMING: All preparation for bare substrates is covered on the appropriate primer datasheet.

BARE GRP: Prime with Gelshield 200 for osmosis protection, or Primocon or Interprotect.

STEEL/IRON/LEAD/WOOD: Prime with Interprotect or Primocon.

PLYWOOD: Prime with Epiglass followed by Interprotect.

Hints

• Mixing: Thoroughly stir until product is mixed to a uniform consistency before use.
• Thinning: Thinning is not recommended. Antifouling performance can be compromised if correct dry film thickness is not applied.
• Cleaner: YTA085 International Antifouling Thinner #3.
• Ventilation and Humidity Control: Ensure adequate ventilation during use.
• Other: Antifoulings should only be wet sanded. Never dry sand or burn­off old antifouling. True colour will develop after immersion

Hazard Warnings

Hazard Pictogram :
Signal Word:	Danger
Hazard Statements:	Flammable liquid and vapour Causes serious eye damage May cause an allergic skin reaction Very toxic to aquatic life with long lasting effects
Precautionary Statement:	General: Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand. Prevention: Wear protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Avoid release to the environment. Response: IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or shower. IF ON SKIN: Take off contaminated clothing and wash it before reuse. IF IN EYES: Immediately call a POISON CENTER or physician. Storage: Keep cool. Disposal: Dispose of contents and container in accordance with all local, regional, national and international regulations.
Hazardous Ingredients	All White: Dicopper Oxide, Rosin, Fatty Acids, C18-unsatd, Trimers, Compds. with Oleylamine, Fatty Acids, Tall-oil, compds. with Oleylamine.
Supplemental Label Elements	Wear appropriate respirator when ventilation is inadequate

Technical Files

Technical Data Sheet

Dover White - Safety Data Sheet

Red - Safety Data Sheet

Blue - Safety Data Sheet

Navy - Safety Data Sheet

Black - Safety Data Sheet