ILCA Laser Rudders & Centreboards

Complete package of Laser® and ILCA® protection for maststep, mast, tiller, outhaul and daggerboard. Contains 2 disks for the maststep, 2 stripes for the maststep and mast deck, 2 stripes for snug fit of the top mast section, 1 stripe for the...

ILCA/Laser Tiller composite construction including flexible joint and rudder down cleat - Class legal for ILCA events Features Flat plate design  Composite carbon fibre and epoxy Includes RWO tiller joint

High quality GRP infused ILCA /Laser Daggerboard to suit all model ILCA Dinghies - Fully approved for use in ILCA events from Olympics to Provincials. With re-inforced trailing edge

ILCA Laser Centreboard Stop Set by Holt How to assemble Allign the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of cap  Fit the part assembled unit to the centreboard and then align and...

The ILCA Laser rudder retaining clip prevents the rudder popping up and becoming detached. The rudder clip is easy to fit but remember to use Sikaflex or similiar sealant to keep the hull watertight.

ILCA Laser Centreboard or Daggerboard Stops - These push-together sets prevent the Daggerboard dropping too low  How to assemble Allign the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of...

The ILCA Laser Friction Pad MK2 is screwed to the back of your daggerboard casing and allows for perfect grip and slip ratio when raising the board.

Laser Rudders Gudgeons by Holt - 2 Required per boat  Fasteners 2 x Sowester Pan Head Self Tappers per Gudgeon - Size  8 x 1 1/2"  Select size here

Genuine ILCA Rudder Gudgeon asteners 4 x Sowester Pan Head Self Tappers per Gudgeon - Size  8 x 1 1/2"  Select size here

This ILCA / Laser tiller retaining pin secures the tiller to the rudder head. Note If your tiller is not drilled to receive the retaining pin, ensure the tiller is firmlypressed into the head before drilling the location hole to ensure solid fit

Official ILCA Rudder Head comes with rudder megabolt.  Suits all models ILCA 4, 6 & 7 and Laser 4.7, Radial and Full Rig

Older style articulated stainless steel tiller joint for smaller sailing dinghies

High quality, reliable RWO OmniflexTiller Joint to suit most dinghy tiller extension, including ILCA Laser, Topper, and many others. This Omniflex joint is made from Elastomeric polymer which allows all directional flexability. The fitting includes a...

The ILCA Mega Bolt is the pivot bolt to fit the Rudder Head to the Rudders Plade - Supplied with 20mm Washers 

Official ILCA fused rudder blade only - Suits all Rigs and Class legal for all ILCA events. Note Also suits Laser (Torch logo) Sailboats.